READ LABEL THOROUGHLY BEFORE APPLYING PRODUCT.
Before You Begin: Surfaces must be clean and free of any contaminants before sealing. Cobble Loc with Grip performance is directly related to how thoroughly the surface is prepared. Do not apply when the temperature of the air or the surface to be coated is below 50°F. Testing on your surface is always recommended to ensure desired results.
Surface Preparation: Smooth concrete must be etched. Scrape and sand all loose material prior to application. Cobble Clean, Cobble Prep, and Cobble Oxhide may be used for specific cleaning situations.
Mixing Instructions:Cobble Loc is a two-component kit. Part A must be mixed with Part B. 1-gallon kits include a quart of Part B, and 5-gallon kits include a short-filled 5-gallon pail and a one-gallon can of Part B. Mix part A and part B with a good power mixer for a minimum of 2 - 5 minutes, and then dilute one part of mixed sealer to one part of water with good mixing.
Applications:
- Roller: Apply with a 3/8” to 3/4” nap roller cover. Avoid over rolling. Always maintain a wet edge. NOTE: It is not recommended to apply Cobble Loc with Grip using rollers; only use if need to back roll to remove excess.
- Airless Sprayer: Spray by overlapping each pass. Always apply in an even film deposit and maintain a working wet line; do not over-apply.
- On Bare Surface: One and sometimes two thin coats (2 dry mils) provide the best results on uncoated surfaces. A second coat can be applied after 4-6 hours of dry time.
- Over Previously Sealed Surface: One coat is recommended.
